Last verified against the primary source on Sep 7, 2026.
DMG Mori NLX 3000/1250 (CNC turning center): real dealer prices.
Confidence 0%2 observed comparables
As of Sep 7, 2026What can make the cheap machine expensive?
| Component | Severity | Documented repair cost |
|---|---|---|
| C-axis spindle drive | medium | not yet verified |
| Spindle brake and chuck | high | not yet verified |
NLX turning centers with the Y-axis milling option use a direct-drive integral-motor spindle for the C-axis, which is inherently easy to back-drive; a shop hogging a large-diameter part with a 12mm endmill got feed-rate oscillation because the NLX line, unlike some competitors, has no drag-brake M-code to damp the axis during heavy milling.
Cost not yet verifiedOn an NLX 2500/700 SY (same NLX-family hydraulic power unit and clamp/brake design used across the line), the main spindle brake stuck clamped and the sub-spindle chuck jaws locked up completely because aged hydraulic oil left a residue on the precision hydraulic valve pistons, which stopped moving even though the solenoids were energized; the fix required manual cleaning and the machine had exceeded the recommended 2000-hour oil change interval.
Cost not yet verifiedCommon questions
How much does a used DMG Mori NLX 3000/1250 cost?
Observed listings range roughly $195,000 to $249,900 depending on age, condition, and configuration (as of 2026-09-07).
What fails on the DMG Mori NLX 3000/1250?
The most cited concerns in our evidence record: C-axis spindle drive, Spindle brake and chuck. See the risk breakdown above for details and sources.
Live listings on eBay
Live listings via the eBay Browse API. Links are affiliate-tracked and CNC Ledger may earn a commission on qualifying purchases, at no cost to you.
From the research record
- MARKET (2 real dealer listings, 2026-09-07): $195,000-$249,900, median $222,450. Exact-model listings; Claude spot-verified a sample.
- RISK (2026-09-08, medium): C-axis / integral spindle drive (Y-axis milling): "An integral spindle that acts as C axis is very easy to back-drive, hence the problem and the solution." https://www.practicalmachinist.com/forum/threads/nlx-not-holding-position-when-milling-with-c-x.393538/
- RISK (2026-09-08, high): Spindle brake / chuck hydraulics: "the selenoid valves themselves do not seem to move even though they are energized." https://www.practicalmachinist.com/forum/threads/dmg-mori-nlx-2500-700-sy-spindle-brake-and-chuck-problem.374145/
Sources
- revelationmachinery.com dealer listingdealer-inventory · verified · accessed 2026-09-07
- theequipmenthub.com dealer listingdealer-inventory · verified · accessed 2026-09-07
- practicalmachinist.com (owner/operator failure report)owner-review · verified · accessed 2026-09-08
- practicalmachinist.com (owner/operator failure report)owner-review · verified · accessed 2026-09-08
Spot an error? Challenge this record
Found an out-of-date code section, a wrong verdict, or a better primary source? Tell us. Corrections that check out are applied, with the change shown in history. That is our standing policy.